Lock Rubber Floor Covering
The Harmony Lock series, obtained by dosing 100% recycled SBR granules with polyurethane binders and color pigments and then pressing with high heat, is applied to flooring Solutions.
Usage Areas
On the grounds of indoor and outdoor children's playgrounds.
Bicycle trails, traffic trails, jogging and walking trails.
Nursing homes, children's hospitals, baby rooms.
At nursing homes and rehabilitation centers.
Classrooms prepared for the handicapped, playground, walking paths.
On shooting ranges.
In school gardens and other garden areas.
Garage entrances and parking lots.
It is possible to use on terrace balconies and in many other indoor and outdoor areas where your mind may arise.
Dimensions
Produced in 200mm x 250mm // 2cm, 2,5cm, 3cm, 4cm Thickness.
Lock Rubber Floor Covering
According to the results of the chemical analysis, 100% recycled rubber granules of 1.00 - 3.00 mm caliber are passed through screens and cleaned.
After the cleaning works, they are mixed with polyurethane based single component binders and UV pigments resistant color pigments in automatic mixers, It must be manufactured after a certain period of molding by applying heat treatment and head in presses.
Polyurethane based single-component binder for the production of molded rubbers Should not be less than 6%.
Iron oxide for red color and chromium oxide pigments for green color should be used in the production of rubber materials.
The average weight of rubber flooring materials is 1 square meter;
It is between 20,50 - 21,50 kg for 25 mm.
Locking rubber flooring material dimensions
200x250x will be in the range of 20, 25, 30, or 40 mm.
Because the material to be laid on the floor is water permeable, there are water channels with the aim of providing drainage at the bottom of the material.
The chamfers must be withdrawn so as to create a joint to the edge portions to allow the surface water on the upper surface of the rubber materials to pass through.
Our products have the required quality certificates.
